Lumberjack job is one of the most arduous but most beautiful at the same time that exists. It requires a good physical condition, but also a lot of caution when doing the work. How to split wood once cut has its technique and also its flats, but with the use of the proper tools, the task becomes much more bearable and is a pleasant experience.
Which One Should I Use – Maul or Axe?
To understand this, it’s necessary to observe certain fundamental differences:
- Although very similar, their functions are different and each has its scope.
- The axe, depending on its size and the thickness of the blade, is more ideal for cutting small or medium trunks, and the maul is used to divide them.
- However, some people do splitting with an axe; the problem with this is that if it is not large enough, the work will be useless, apart from the problem of mending the blade. For this, it is better to use the maul and the wedges.
Before Using a Maul – First Prepare Wood
- Appropriate log size: A length of 33-40 centimeters is recommended to make it easy to stack firewood. If the logs are only a little shorter, the
woodpile will collapse easily.
- Prepare chopping level: To achieve this, a good cutting block is required. It is recommended to level the same, which should be large and flat, as this will lessen the hassle of being crouched and will facilitate the use of wedge hammer and mallet. When cutting wood that has a length of 30-40 centimeters, the cut block should be up to the knee or lower.
- Keep safety – hold your maul tight: Traditionally, the splitting maul is meant to divide the logs: it is placed on the cutting block, and the maul is swung over the shoulder or head, down, hitting the log in the grain – where the log is beginning to split – to separate the wood. As a suggestion, to avoid back problems in the future, it’s good to place the trunk or logs on a rubber tire so that when you split it, each piece is still kept relatively upright and easy to pick up.
How to Use a Splitting Maul to Split Wood
- Place the log in the center: It’s the best position for cutting, vertically so that the impact is in the pulp and not in the crust of the pulp.
- Check thoroughly: Seeing the integrity of the trunk and detect cracks that are the route to cut it and divide it better.
- Target to the point of splitting: Once the cracks or weak points in the log are detected, aim well. If it’s necessary to give two strokes in a row, do not inhibit; of course, with caution.
- Chop in the vertical direction: It has already been explained in an earlier point and is the only possible way.
- Splitting into smaller If the wood does not Split: Don’t expect the trunk to be divided thus in a single blow, that will depend on the size of it and the maul; if you have to divide it into more than two pieces, do it.
1. Age of the Wood:
It’s a very important aspect to take into account by the woodcutter, or you in this case. There are several methods to determine it, although the most usual is the growth ring count and the successive measurements of the trees. This information is important to know if a trunk type is younger or older, and the quality of the timber will depend on it.
2. Moisture: Another
aspect to keep in mind. Once the logs have been cut, the wood must be dried because it contains up to 50% water and in this condition, it may not be usable for certain purposes, such as to put it in the fire. You can check the amount of moisture in wood using a wood moisture meter.
3. Take rest in time:
This is a very arduous task and there is nothing wrong with taking small breaks between five and ten minutes. If you can, hydrate yourself with water or moisturizing drinks. And do not skip meals, you will require a lot of energy.
4. Avoid unsafe conditions:
It’s not recommended to perform this work at night because of the dangers of insecurity or attacks of wild animals. There are also storm warnings or in very isolated places of civilization.
Finally, we have seen that how to split wood is a technique and requires great effort. But with the support of the tools and tips that were given to put into practice and as has been expressed previously, the work will be a rewarding and learning experience. Apart from getting the benefit of the wood that nature gives us.